Vacuum suction machine cleaning method

Vacuum suction machine is a common cleaning equipment, widely used in factories, laboratories, hospitals and other places. In order to ensure the normal operation of the suction machine and extend its service life, it is important to clean it regularly. Next, the cleaning method of the vacuum suction machine will be introduced to maintain its good working condition.

The cleaning method is divided into the following steps:

1. Stop the work of the suction machine and disconnect it from the power supply. When it is completely stopped, put the suction machine on a clean work table, ready for cleaning.

2. First, clean the shell of the suction machine. Use a wet rag or sponge to dip an appropriate amount of detergent and wipe the outer surface and surrounding parts of the suction machine, including the suction hopper, filter, etc. Be careful not to allow water or detergent to enter the inside of the suction machine.

3. Clean suction hopper and filter. Remove the suction hopper and dump the residue. Rinse the suction hopper with clean water and scrub the inside and bottom with a brush or sponge. After it is completely dry, put it back into the suction machine again. Then, remove the filter, rinse it with clean water, and gently scrub its surface with a brush. Soak in warm water, making sure to wash thoroughly. Then let dry.

4. Clean the pipe and connection parts of the suction machine. If you find a blockage, you can use a needle to clean it up.

5. Clean the suction nozzle or straw. Remove the suction nozzle or straw, rinse with water, and clean the inside with a brush. Again, dry thoroughly and connect again to the suction machine.

6. Clean the vacuum pump or motor. This is the most important step in the cleaning process. First, close the valve of the vacuum pump or motor and disconnect it from the suction machine. Then, wipe the shell of the vacuum pump or motor with detergent and a sponge, and clean its internal components. According to the actual situation, special tools can be used for cleaning. Make sure all areas are completely cleaned. , dry and reconnect to the suction machine.

7. Check whether each connection part is loose or damaged. If there is a problem, repair or replace it promptly.

The above is the cleaning method of the vacuum suction machine, through regular cleaning and maintenance, you can ensure the normal work of the suction machine. Pay attention to safety during cleaning to avoid excessive force and damage to parts. In addition, the frequency of cleaning can be adjusted appropriately according to the actual situation and frequency of use of the suction machine.